BEFORE OPERATION OF THE MACHINE EACH DAY, DO A CHECK OF THE FOLLOWING ITEMS. LOCK OUT POWER TO THE MACHINE AND OBEY ALL SAFETY REGULATIONS BEFORE DOING MAINTENANCE. ALSO FOLLOW SPECIFIC SAFETY PRECAUTIONS AT THE BEGINNING OF THE INSTALLATION, OPERATION AND MAINTENANCE SECTIONS IN THE FULL ROTEX MANUAL.

  • Inspect cable assemblies, if equipped, for wear and uniform tension. Inspect cable attachment hardware for wear or damage. Replace cables and/or adjust turnbuckles as required.

  • Inspect hanger assemblies, if equipped, for loose bolts, broken parts, or failed bearings.

  • Inspect floor mounting bolts, if equipped, to make sure they are tight.

  • Inspect drive mounting hardware for loose or missing bolts.

  • Inspect connectors for tears or leakage. Replace or adjust as necessary.

  • Do not operate the machine without all drive and/or belt guards installed. Check for slipping belts.

  • All top cover clamps, door clamps, screen frame jacking bolts and top cover jacking bolts, if equipped, must be installed and correctly adjusted.

  • All pneumatic clamps, if equipped, must be correctly inflated.

  • Make sure all inspection caps and access panels are installed.

  • Inspect discharge end drag link (horizontal stabilizer bar), if equipped, for noise or excessive looseness.

  • Inspect slide bearing assemblies for wear. If slide bearing is greased-type, make sure to follow the recommendations for grease specifications, quantity and lubrication frequency.

  • Inspect motor wiring for wear or damage.

  • Remove all loose items, such as tools, from the machine.

  • Make sure the area around the machine is clear of product and other items.